Category Archives: Projects

ADE 7763 Part-10 (Not much)

I found the cause of my power switching from positive to negative. I would scope the current and voltage inputs one day and they would be in phase. The next day or even later that day they would be 180 … Continue reading

Posted in Home Energy Monitor, Projects | Comments Off on ADE 7763 Part-10 (Not much)

ADE7763 Part-9 (My Problem)

As I kind of suspected, Analog got back to me and informed me that the ADE7763 was a very mature product and that the reversal of IRMS and VRMS was never reported. Now unless NOBODY has ever tried to read … Continue reading

Posted in Home Energy Monitor, Projects | Comments Off on ADE7763 Part-9 (My Problem)

ADE7763 Part-8 (Bad datasheet?)

I last left with a puzzle on my mind. The VRMS and IRMS registered seemed to be reversed. Changing the load did not vary the IRMS register by rather the VRMS. I figured I had screwed something up in the … Continue reading

Posted in Home Energy Monitor, Projects | Comments Off on ADE7763 Part-8 (Bad datasheet?)

ADE7763 Part-7 (Mystery of the swapped VI)

In my last port I alluded to the mysterious swapping of the voltage and current channel. When I read the Vrms and Irms channels under various loads, it is the voltage channel that changes significantly and not the current. I … Continue reading

Posted in Home Energy Monitor, Projects | Comments Off on ADE7763 Part-7 (Mystery of the swapped VI)

ADE7763 Part-7 (peeling back the onion)

My ADE7763 is connected to an Arduino and I am now working on the interface code to aid in system testing. I sent several hours today with my mixed signal scope (2 channels of analog and 16 digital) debugging. What … Continue reading

Posted in Home Energy Monitor, Projects | Comments Off on ADE7763 Part-7 (peeling back the onion)

ADE7763 Part-6 (first system test)

Just started the first system testing of the ADE7763. What I mean is rather than just working on the SPI or other subsystems, I am using the chip as it would be in real life. I have the voltage and … Continue reading

Posted in Home Energy Monitor, Projects | 7 Comments

ADE7763 Part 5 (pictures and a schematic)

I have had an offline conversation with a reader about my endeavors with the ADE7763. Their application is similar to mine, but rather than monitoring at the breaker panel they wish to monitor (and control) at the plug level. I … Continue reading

Posted in Home Energy Monitor, Projects | 7 Comments

ADE7763 Part-3

Managed to get some time to play with the ADE7763 over the weekend. During testing of the SPI interface I found numerous problems with timing that I corrected. I am now fairly confident that the underlying digital interface to the … Continue reading

Posted in Home Energy Monitor, Projects | 4 Comments

ADE7763 Part-2

Having recently gotten my DigiKey order I installed the crystal and its load caps on the breadboard circuit. Next I started to work on the communications to the ADE. I quickly learned that the Endian-nes of the ADE and and … Continue reading

Posted in Home Energy Monitor, Projects | Comments Off on ADE7763 Part-2

ADE7763 for energy monitor

Stumbled across the Analog Devices ADE7763 IC. It is a chip dedicated to single phase energy monitoring. It has inputs for current and voltage sensors. The chip takes these values, computes the RMS values, takes the product, and integrates it … Continue reading

Posted in Home Energy Monitor, Projects, Uncategorized | Comments Off on ADE7763 for energy monitor